Comments on: ProForm GT 95 X CrossTraining Recumbent Exercise Bike http://www.recumbentstationarybike.net/proform-gt-95-x-crosstraining-recumbent-exercise-bike/#utm_source=feed&utm_medium=feed&utm_campaign=feed Sun, 29 Nov 2009 00:00:00 -0500 http://wordpress.org/?v=2.9.1 hourly 1 By: Peter Hanks http://www.recumbentstationarybike.net/proform-gt-95-x-crosstraining-recumbent-exercise-bike/comment-page-1/#comment-305 Peter Hanks Sat, 21 Nov 2009 00:00:00 +0000 http://www.recumbentstationarybike.net/proform-gt-95-x-crosstraining-recumbent-exercise-bike/#comment-305 Excellant Recumbent<br>Rating:5 out of 5 stars<br> <br />I use this GT 95 every day. I love it. <br /> <br />I put it together with one arm following shoulder surgery. Excellant Recumbent
Rating:5 out of 5 stars

I use this GT 95 every day. I like it.

I place it together with one arm following shoulder surgery.

]]> By: T. Melland http://www.recumbentstationarybike.net/proform-gt-95-x-crosstraining-recumbent-exercise-bike/comment-page-1/#comment-306 T. Melland Sat, 21 Nov 2009 00:00:00 +0000 http://www.recumbentstationarybike.net/proform-gt-95-x-crosstraining-recumbent-exercise-bike/#comment-306 You might want a drill press handy...<br>Rating:3 out of 5 stars<br>The first task in the assembly is the front support pipe (yes I grabbed the smaller one per instructions), the holes in the pipe are 1' too far apart (hence the need for a drill press). There's no mention of an adapter plate nor is there any reference to one in the diagram so..... I have a drill press so I can fix that, but not everyone has one or has access to one and I wouldn't recommend trying to 'freehand' it. Until I finish the assembly I'll reserve further judgment but ProForm should be better than this ....... You might want a drill press handy…
Rating:3 out of 5 stars
The first task in the assembly is the front support pipe (yes I grabbed the smaller one per instructions), the holes in the pipe are 1′ too far apart (hence the need for a drill press). There’s no mention of an adapter plate nor is there any reference to one in the diagram so….. I have a drill press so I can fix that, but not everyone has one or has access to one and I wouldn’t recommend trying to ‘freehand’ it. Until I end the assembly I’ll reserve further judgment but ProForm should be better than this …….

]]>